Adjusting Pulley Sensors¹

Rotate pulley (B) so that the magnet (C) is just aligned with sensor (A).

Distance (D) should be 2 to 4 mm (0.08 to 0.16 in.). If not, loosen lock nuts (E), then slide sensor (A) until specified distance (D) is achieved.

Slightly tighten lock nuts (E) and rotate the pulley several times to check that there is no interference between sensor and magnet.

A-Sensor
B-Pulley
C-Magnet
D-2 to 4 mm (0.08 to 0.16 in.)
E-Lock nuts

OUCC006,000041D -19-15JUN01-1/1