Using Bale Counters

The monitor is equipped with six bale counters: one total counter (D) and five resetable current counters (B) which can be used to store daily number of bales or number of bales per field.

Two conditions must be met to add a bale to the current and total counters: the bale must be tied and the gate must be opened and closed.

In normal operating mode, the selected current counter is displayed for five seconds following bale ejection.

To select a current counter (B), press several times on "COUNTER" key (A) until the desired counter (C) is displayed. After five seconds without pressing any key, the monitor returns to normal display mode and the last displayed current counter is selected. The new bales will be added in the selected counter.

If the last counter displayed is the total counter (D) the current counter selected (B) is the current counter from the last selection (for example 3).

Press "COUNTER" key (A). The last selected current counter (B) is displayed for five seconds.

While a current counter (B) is displayed, press several time "COUNTER" key (A) until the monitor displays the total counter. (Total counter will be displayed after the fifth counter.)

Current counters can be increased to add bales or decreased to subtract bales.

While the desired current counter is displayed, press "PLUS" or "MINUS" key to increase or decrease number of bales.

A-Counter key
B-Current counter
C-Current counter
D-Total counter

OUCC006,0000693 -19-13MAY02-1/2

NOTE: A continuous pressure on "MINUS" key will reset the counter displayed.

The last number of bales displayed is stored after five seconds.

NOTE: Adding or removing bales from current counter will not affect the total counter.

To reset a current bale counter, press and hold "MINUS" key while a current counter (B) is displayed. The counter displayed will begin to decrease then reset.

NOTE: Total bales counter can not be changed or erased.

OUCC006,0000693 -19-13MAY02-2/2