Diagnostic Trouble Codes

When an error occurs on the round baler, the monitor displays the Stop indicator (A), a sound alarm is emitted and the diagnostic trouble code (B) is displayed.

Some of the diagnostic trouble codes are displayed 5 seconds then disappear.

It is possible to clear some of the diagnostic trouble codes from the LCD screen by pressing the "MINUS" key.

To clear some other of the diagnostic trouble codes, it is necessary to correct the malfunction. Press the "MINUS" key to stop the buzzer then correct the problem corresponding to the diagnostic trouble code (See "Diagnostic Trouble Code List" in "BaleTrak Monitor Service" section).

A-Stop indicator
B-Diagnostic trouble code

OUCC006,0000695 -19-13MAY02-1/1