Removing and Installing Net Knife

CAUTION: Prevent personal injury by wearing gloves to handle net knife.

Note position of knife cutting edge for reinstallation.

Open net tying cover.

Fully extend net actuator and disconnect actuator plug.

Remove fixing screws (A) of knife (B), then remove knife (B) from its brackets.

Install knife (B) on its brackets in the same position as before removal.

Secure knife by means of fixing screws (A). Tighten screws to 55 N·m (40 lb-ft).

Reconnect actuator plug and retract actuator. Close net tying cover.

IMPORTANT: Always carry out "Test 1" of net tying device check procedure after having installed net knife (see "Checking Knife and Counterknife Position" in this Section).

A-Fixing screws
B-Knife

OUCC006,00006A5 -19-21MAY02-1/1