Channel 005: Calibration of Bale Size Potentiometer
"CH005" allows to set bale size potentiometer. Open gate to move belt tension arm to its highest position with tractor selective control valve lever. Press "PLUS" key to display the setting value corresponding to baler model. Loosen the two fixing screws (B), then rotate the potentiometer (A) so that monitor beeps continuously and LCD screen displays the value (± 5) corresponding to baler model. Tighten fixing screws (B). IMPORTANT: After the calibration of bale size potentiometer, make adjustments described in channel 27 and channel 28 so that the measured bale diameter corresponds to the desired diameter adjusted on monitor.
|
|
OUCC006,00006A8 -19-22MAY02-1/1 |