A-20.5±0.5 mm (0.8±0.02 in.)
B-Spring adjusting nuts

C-Spring

D-Rubber roll

E-Plated roll

IMPORTANT: Prior to carry out this test, make sure that test 1 and 2 results are "OK". Proceed to the relevant tests described in this Section.

Proceed as follows:

Release net feed roll brake, see "Loading Net Tying" in "Preparing the Baler" section.

Adjust net feed roll pressure by loosening or tightening spring adjusting nuts (B) until length of springs (C) is 20.5±0.5 mm (0.8±0.02 in.)

IMPORTANT: Make sure that rubber roll and plated roll rotate freely by hand in both directions with springs adjusted to 20.5±0.5 mm (0.8±0.02 in.).

Remove any foreign material or net from between the feed rolls.

Proceed to test 4

OUCC006,00006CD -19-30MAY02-1/1