Disengaging Bale Push Bar (592 Only)

Bale push bar will remain in home position, regardless of gate movement, when in the disengaged position.

To disengage push bar:

Remove quick lock pin (E) and washer (C) from gate pin.

Remove tension from chain by rotating spring assembly (A). Remove end chain link from gate pin.

Let chain hang freely to remove any twists.

2. Attaching Chain to Hook

Rotate spring assembly (A) to the rear.

Attach the end chain link (B) to hook.

Install washer (C) and quick lock pin (E) on gate pin (D).

Repeat on opposite side.

IMPORTANT: Both chains must be attached to lockout hooks to lock out push bar. Damage can occur to the push bar and/or gate if one chain is left attached to the gate pin or is unhooked completely.

NOTE: If operating the baler with push bar disengaged, it will be necessary to back up baler before ejecting the bale.

A-Spring assembly
B-Chain link
C-Washer
D-Gate pin
E-Quick lock pin

OUCC006,000071D -19-11JUL02-1/1