Switching the Monitor On or Off

Press "ON/OFF" key (A) to switch on the monitor.

During the power-up:

  • All the pictograms are displayed.
  • The buzzer beeps for one second.
  • Then, the model number (B) is displayed for one second.

NOTE: The baler model number is followed by a "C" if the baler is equipped with a precutter device.

After the power-up sequence, the monitor enters in normal display mode and the closed gate pictogram (C), the net or twine tying pictogram (D) and the minimum bale size detected (E) are displayed.

To switch off the monitor, press "ON/OFF" key (A), OFF is displayed for one second then the monitor is off.

NOTE: After 30 minutes without any operation, the monitor will power off by itself.

If the voltage is higher than 16 V for 5 seconds, the monitor will automatically power off.


A-On/off key
B-Baler model
C-Closed gate pictogram
D-Twine tying pictogram
E-Minimum bale size detected

CC1019799

OUCC006,00009B6 -19-15JUL03-1/1