Adjusting 2.20 m (7 ft 3 in.) HiFlow Pickup Drive Chains

To ensure that all slack is removed from chains, close gate and engage PTO a few seconds. Shut off tractor engine.

Adjust tension of pickup drive chains as follows:

Main Drive Chain (B)

If spring coils (A) are jointed together, remove one link from drive chain (B).

Crankshaft Drive Chain (E)

For baler without tension indicator (C): Tighten or loosen tensioner adjusting nut (D) so that chain deflection to the opposite strand of idler is about 7 mm (0.27 in.).

For baler with tension indicator (C): Tighten or loosen tensioner adjusting nut (D) so that back face of tensioner adjusting nut (D) is aligned with tension indicator end.

Pickup Cylinder Drive Chain (F)

Loosen the idler mounting screw.

Press idler (G) against chain so that chain deflection to the opposite strand of idler is about 10 mm (0.39 in.)

Tighten the idler mounting screw.

Right-Hand Auger Drive Chain (J)

If spring coils (H) are jointed together, remove one link from drive chain (J).

Left-Hand Auger Drive Chain (L)

Loosen the idler mounting screw.

Press idler (K) against chain so that chain deflection to the opposite strand of idler is about 10 mm (0.39 in.)

Tighten the idler mounting screw.

Engage PTO a few seconds.

A-Spring
B-Main drive chain
C-Tension indicator
D-Tensioner adjusting nut
E-Crankshaft drive chain
F-Pickup cylinder drive chain
G-Idler of pickup cylinder drive chain
H-Spring
J-Right-hand auger drive chain
K-Idler of left-hand auger drive chain
L-Left-hand auger drive chain

OUCC006,0000EB3 -19-19JUL05-1/2

Check deflection of the chains. Repeat adjustments if necessary.

OUCC006,0000EB3 -19-19JUL05-2/2