OMCC58667: 572, 582 and 592 Round Balers(70000- ), Block File: OUCC006_0000EE4_19

Adjusting Wheel Spindles-Baler with 2.00 m (6 ft 7 in.) and 2.20 m (7 ft 3 in.) HiFlow Pickup

causym CAUTION: Always make sure that baler is securely supported by the jackstand before adjusting wheel spindles. Do not forget to block up wheel on opposite side.

Feeding difficulties may occur in extreme conditions such as brittle dry crops or large windrows. This problem can be solved by adjusting clearance between ground and machine according to crop conditions. Two wheel spindle positions are usable:

Positions 1 and 2 should not be used as this will result in too low pickup position.

Position 3 allows the machine to be lowered. This position is recommended when baling hay, alfalfa and silage.

Position 4 allows the machine to be raised. This position is recommended when baling straw.

For baler equipped with wheel nuts, tighten the wheel spindle bolts to the following specifications:

Specification

Wheel Spindle Bolts (Baler with Wheel Nuts) -Torque

235 N·m

(173 lb-ft)

For baler equipped with wheel bolts, tighten the wheel spindle bolts to the following specifications:

Specification

Wheel Spindle Bolts (Baler with Wheel Bolts) -Torque

350 N·m

(258 lb-ft)

Make sure bolt heads face outward.

OUCC006,0000EE4 -19-21JUL05-1/2

IMPORTANT: After adjusting wheel spindles, always adjust tongue to tractor drawbar or to tractor trailer hitch and bale discharging ramp. (See "Adjusting Tongue to Tractor Drawbar" or "Adjusting Tongue to Tractor Trailer Hitch" in "Attaching and Detaching" Section and see "Adjusting Bale Discharging Ramp" in this Section.)

OUCC006,0000EE4 -19-21JUL05-2/2