Installing BaleTrak Monitor on the Tractor

Install BaleTrak control monitor on the provided support.

The power supply must be 12 Volt, 30 A with fully charged battery. A minimum of 20 A is required during electrical cylinder retract cycle.

IMPORTANT: Over voltage should not be higher than 16 V.

Under voltage should not be below 11.2 V as under this value the BaleTrak control will not work correctly and a diagnostic trouble code will be displayed. This can occur when battery is flat or if battery connections are not good. Always check battery voltage and connections by actuating the actuators before operating the baler.

NOTE: Due to the high level of ripple current (over voltage), do not perform any BaleTrak test with the battery connected to a battery charger.

The BaleTrak control monitor is reverse voltage protected.

OUCC006,0000F2A -19-22JUL05-1/1