Adjusting Upper Arm Cylinder (572 and 582 Baler)

If hydraulic cylinder (A) has been replaced, adjust cylinder as follows:

1. Close the gate and lower the belt tension arm.

2. Pull out cylinder rod (B) until dimension (C) is:

Specification

Upper Arm Cylinder (572) -Length 233 mm (9.17 in.)
Upper Arm Cylinder (582) -Length 255 mm (10.04 in.)

3. Install and screw in strap (D) so that it is possible to install cylinder fixing screws (E).


A-Hydraulic cylinder
B-Cylinder rod
C-Length
D-Strap
E-Fixing screws

CC010042

OUCC006,0000F32 -19-21JUL05-1/1