Setting Center Tension Arm Roll Position (NR 12) (572 and 592)

IMPORTANT: Set the center tension arm roll position according the crop type. Failure to do so could result in baler damage.

1. Fully open the gate and lock it using the safety lock device.

2. Use the tractor selective control valve lever to move the tension arm until that roll cap screw (A) is aligned with the access hole (B) inside the baler.

3. Engage tractor parking lock, shut off tractor engine and remove key.

4. Support roll and loosen cap screw (A) on both sides.

5. Set the center arm roll position:

Position 1: Set the roll in this position when the machine is used to bale dry crop like straw.

Position 2: Set the roll in this position when the machine is used to bale wet crop like silage.

6. Tighten cap screw (A) on both sides to specifications:

Specification

Center Tension Arm Roll Cap Screws -Torque 130 N·m (97.5 lb-ft)

CC1027205


A-Cap screw
B-Access hole
1-Position for dry crop
2-Position for wet crop

OUCC006,0001177 -19-26SEP06-1/1