Adjusting 2.00 m (6 ft 7 in.) and 2.20 m (7 ft 3 in.) Rotary Feeder Pickup Caster Gauge WheelsIMPORTANT: Caster gauge wheels are not designed to be in constant contact with the ground. 1. Adjust the pickup height.2. Act on selective control valve lever to fully lower the pickup. 3. Remove spring-locking pin (A) then choose one of the positioning holes (B) to fix support (C) so that caster gauge wheel is just above the ground (caster gauge wheel must be approximately at the same height as pickup teeth). 4. Install spring-locking pin (A). Repeat procedure on opposite side.
|
|
OUCC006,000117C -19-13OCT06-1/1 |