Channel 028: Fine Tuning Bale Size

Depending on the crop baled, it can occur that the measured bale diameter does not correspond to the desired diameter adjusted on monitor.

CAUTION: Before modifying this adjustment, make sure that channel 5 and channel 27 are correctly adjusted.

In "CH028", the monitor can be fine tuned to recover the real desired bale diameter.

Make a bale with a diameter of:

• 110 cm (3 ft 7.3 in.) for 572 baler
• 130 cm (4 ft 3.2 in.) for 582 and 592 balers

Measure the current bale diameter.

Select the channel 28.

In "CH028", press "PLUS" or "MINUS" key to display the current bale diameter measured.

The last bale diameter entered is stored.

NOTE: To check actual bale diameter, measure bale horizontally and vertically on both ends. Add the four measurements together and divide by four to determine average bale diameter.

OUCC006,00011B9 -19-18JAN07-1/1