Adjusting Rotary Feeder Reverse Sensor

To adjust sensor (A), proceed as follows:

1. Check that rotary feeder is not in reverse operating mode. See "Reversing Rotary Feeder" in "Operating BaleTrak Monitor" section.

2. With hydraulic cylinder fully retracted, check that magnet (B) is aligned with sensor (A).

3. Check that distance (C) between sensor (A) and magnet (B) is within specification:

Specification

Sensor to Magnet -Distance 10 ± 1 mm (0.4 ± 0.04 in.)

If necessary, adjust sensor (A) as follows:

a. Loosen lock nuts (D) and slide sensor (A) until distance (C) is obtained.

b. Tighten lock nuts (D).

4. With BaleTrak ™ monitor, check sensor detection. See "Channel 024: Test of Rotary Feeder Reverse Sensor" in "BaleTrak Monitor Service" section.

CC007181


A-Sensor
B-Magnet
C-Distance
D-Lock nuts

BaleTrak is a trademark of Deere & Company

OUCC006,0001278 -19-23OCT07-1/1