Adjusting Soft Core Diameter

The gate must be closed and the tension arm fully down before making soft core diameter adjustment.

Adjust as follows:

1. Loosen wing nut (A).

2. Turn soft core cam (B) until desired mark is level with switch roller (C).

Adjusting ranges are:

  • From "1" to "4.5" on 572 baler.
  • From "1" to "5" on 582 baler.
  • From "1" to "6" on 592 baler.

3. Tighten wing nut (A) and check that soft core cam (B) is still aligned with switch roller (C).

IMPORTANT: Diameter of soft core should never be greater than bale size selected. On 592 baler with 0 bar soft core kit, the gate cannot be opened if the switch (D) is still activated by the soft core cam (B).

CC1026243


A-Wing nut
B-Soft core cam
C-Switch roller
D-Switch

OUCC006,0001289 -19-28SEP07-1/1