Adjusting Pickup Roll Compressor Height (if Equipped)

Adjust the pickup roll compressor (A) height as follows:

2. Remove chain (B) from anchor (C) on both sides.

3. Slowly lower the pickup until the top of pickup roll compressor (A) and the top of the windrow are aligned.

4. Attach chain (B) on anchor (C) as shown, leaving the minimum of chain links (B).

NOTE: Check that the number of chain links (B) is the same on both sides.

5. Fully lower the pickup.

6. Check pickup roll compressor height, repeat procedure if needed.

A-Pickup roll compressor
B-Chain
C-Anchor

OUCC006,0001311 -19-05SEP07-1/1