Adjusting Starter Roll (NR 1) Scraper (Baler with Rotary Feeder Pickup)

1. Adjust scraper (C) as close as possible to bottom roll (B), leaving enough space (A) to avoid any contact with bottom roll.

2. Adjust scraper (C) as follows:

a. Loosen screws (D) then adjust space (A).

b. Manually rotate baler to check distance at all bars. See "Rotating Baler by Hand" in "Operating the Baler-General Purposes" section.

3. Tighten fixing screws (D) to following torque:

Specification

Starter Roll Scraper Fixing Screws -Torque 140 N·m (103 lb-ft)

CC1019230


A-Space
B-Starter roll
C-Scraper
D-Screws

OUCC006,0001315 -19-07SEP07-1/1