Manual Start of Tying Cycle

IMPORTANT: Channel 032 must be deactivated to start a tying cycle manually. See "Channel 032: Automatic Start of Tying Cycle" in "BaleTrak Monitor Service" section.

I - Just before the set bale diameter is reached, the near full pictogram (A) flashes and the monitor beeps twice. The near full diameter at which the pictogram flashes is adjustable. See "Channel 010: Offset of Nearly Full Alarm" in "BaleTrak Monitor Service" section.

II - When the adjusted bale diameter is reached, the monitor beeps continuously for 3 seconds and the stop indicator (C) is displayed. Immediately stop the tractor.

Manually start an automatic tying cycle by pressing (D) or tie bale manually by pressing (E). See "Manual Start of an Automatic Tying Cycle" and "Tying a Bale Manually" in this section.

A-Near full pictogram
B-Twine pictogram
C-Stop indicator
D-Manually start an automatic tying cycle key
E-Extend key

OUCC006,0001325 -19-03OCT07-1/1