|
The following procedure should be carried out when net cut or net tying problems occur during field operation.
The check procedure includes different tests to carry out:
-
Test 1 - Checking knife and counterknife position
-
Test 2 - Checking free motion of swinging bar
-
Test 3 - Checking net feed roll pressure
|
-
Test 4 - Checking NR 8 roll position
-
Test 5 - Checking drive belt tension
-
Test 6 - Checking net feed roll brake
-
Test 7 - Checking tension arms
-
Test 8 - Checking net cut switch adjustment
-
Test 9 - Checking lower net guide position
NOTE:
When all test results are "OK", the net tying device is then optimized for good field operation.
|