Basic Adjustment of Plungerhead with Needles

CC9135-UN-25SEP98

A - Face of Plungerhead in Slot on Side of Bale Case

B - Needle Flush with Top Edge of Bale Groover

C - Face of Plungerhead

D - Needle

On Twine Baler:

Position plungerhead to needles as shown.

NOTE: It is preferable to adjust plungerhead (C) closer to front than to rear of slot (A).

CC9136-UN-06OCT98

A - Face of Plungerhead in Slot on Side of Bale Case

B - Needle Flush with Top Edge of Bale Groover

On Wire Baler:

Position plungerhead relative to front of needle pulley as shown.