Connect Telescoping Driveline to Tractor PTO Shaft

CC1020007
CC1020007-UN-09JUL01

CC007602
CC007602-UN-02OCT96

CC1034425
CC1034425-UN-15SEP11

A - Locking Collar

B - Guard

CAUTION: Never attach telescoping driveline while the tractor is running.

Never use a steel hammer to connect or disconnect the driveline on PTO shaft.

IMPORTANT: Keep driveline and PTO shaft splines free from paint, dirt, chaff and burrs.

  1. Disengage the PTO, engage park brake and/or place transmission in PARK, shut off tractor engine and remove key.

  2. Pull back on locking collar (A). Locking collar (A) will ”click” and remain in open position.

  3. Connect telescoping driveline to tractor 540 or 1000 rpm PTO shaft. Refer to tag on baler to select tractor PTO speed. Push telescoping driveline onto tractor PTO shaft until locking collar (A) snaps forward. Locking collar (A) will ”click” two times.

    IMPORTANT: The locking collar (A) must rotate freely to indicate that the telescoping driveline is correctly latched to the tractor PTO shaft.

  4. To check if telescoping driveline is latched, pull back on guard (B). Do not pull on locking collar (A), as this will release latch.

NOTE: Refer to the basic telescoping driveline Operator's Manual to properly connect telescoping driveline to the tractor PTO shaft.

OUCC006,00017BE-19-20111024