VisionTrak™ Operational Checks

1. NOTE: Two people are required to perform this operational check. One person must remain seated in the operator's seat, while another person taps on the sensors.

   NOTE: Separator sensors are on the left-hand side of the machine underneath the separator covers.

   NOTE: Shoe sensors are at the rear of the machine on the tailboard.

   Turn key switch to RUN position, but do not start machine.

2. Engage header switch.

   NOTE: MUST be in a crop that was previously calibrated. Grain loss calibration value MUST be less than 50.

3. 
   H120521-UN-19JAN17

   Separator Sensors

   
   H120618-UN-26JAN17

   Right-Hand Shoe Sensor

   Tap on sensors (A) several times. Person watching VisionTrak™ display should see movement on the shoe loss and separator loss indicators.

---




4. Disengage header switch and turn key switch OFF.

   NOTE: Return grain loss calibration value to original value or perform another crop calibration.

5. If VisionTrak™ does not work after these checks, see your John Deere dealer for further information.