Error Codes, INFOTRAK Monitor

Whenever the infotrak monitor displays a three-digit number followed by an "E", a malfunction or error by the operator is indicated. The cause of a machine malfunction may be a broken wire etc.

IMPORTANT: If no solution is given or if the problem cannot be eliminated, consult your John Deere dealer.

Error code Problem Solution
101E Counter of engine operating hours in infotrak monitor is defective  
102E Working hour counter of infotrak monitor is defective.  
122E Concave cannot be adjusted, sensor signals not in correct area (too low) Check fuse (F27)
123E Concave cannot be adjusted, sensor signals not in correct area (too high) Check fuse (F27)
128E No reaction from infotrak monitor  
129E    
130E Adjusting motor cannot reduce fan speed to the desired rpm Check fuses (F8, F30)
131E Variator cannot reduce cylinder speed to the desired rpm Check fuse (F8)
132E Adjusting motor can not reduce concave clearance to desired gap Check fuse (F27)
135E Adjusting motor cannot increase fan speed to the desired rpm Check fuses (F8, F30)
136E Variator cannot increase cylinder speed to the desired rpm Check fuse (F8)
137E Adjusting motor cannot increase concave clearance to desired gap Check fuse (F27)
139E With EPROM versions 7 or 9 Engine speed at "automatic machine adjustment" is less than 2000 rpm, or the separator is switched off.

 

AG,CO03622,2225 -19-05NOV02-1/1