Tensioning Steel Track
To keep unnecessary wear from occurring on the chain links as well as on the guide wheels, drive wheels and bearings, tension the chain correctly on both steel tracks using the following procedure:
1.
On a flat and level place, move the combine back slightly and then check the deflection (X) by pressing the chain at the position indicated by the arrow.
2.
With a ruler, measure the deflection (X), which should be between 40 and 50 mm.
3.
Tension the chain if needed. To tension the chain loosen bolts (1) on guide wheel bearings and then locknuts (2), tension chain by turning bolts (3) at the same time using the spanner included with steel track. Retighten bolts (1 and 2).
NOTE:
Be careful to move bearings at the same time in order to maintain guide wheel alignment.
IMPORTANT:
Never operate the Combine with chains too tight, this not only stresses the whole set, it also causes excessive chain wear. Operating with a loose chain can also cause excessive wear of lower rollers and drive wheel teeth.
|