Feeder House/Header Reverser

IMPORTANT: Raise reel before engaging reverser. Backing out a crop "slug" into a turning reel may damage it.

I - Disengage header drive (using header drive switch) and back up combine 1-2 m (3-6 ft). Run engine at slow idle speed.

II - Step on left-hand side of reverser pedal and hold pedal down to engage reverser and header.

NOTE: The pedal must be held down or else reverser will not engage.

III - Step on right-hand side of reverser pedal to disengage reverser function.

IV - Engage header for normal function.

Run engine at high speed and resume harvesting.

IMPORTANT: During reverser operation, never attempt to force "slugs" through combine by repeated cycling of reverser drive. Repeating reverser cycles shortens the working life of components.

NOTE: For safety reasons the reverser works only with threshing engaged and header disengaged.

For emergency stop, use the "QUICK STOP" switch on the multifunction control handle. In this situation the reverser disengages even with the pedal pressed down; to reactivate this function the pedal must be released then pressed down again.

NOTE: Only CWS/WTS combines with operator presence switch: This switch will disengage this function when activated. To reengage it, sit down again on operator seat and turn the corresponding switch OFF and ON.

ZX002453
ZX009601
CQ194681

AG,CO03622,1398 -19-20AUG04-1/1