Operational Check of Harvest Performance Monitor
CAUTION:
Do not start engine.
Move road safety switch to field position.
Turn starter key from position (0) to position (II)
Switch threshing unit to ON position.
I - Straw Walker Sensors Check:
·Turn potentiometer (A) clockwise as far as it will go.
·Place rotary switch (B) in the position for medium grain.
·Rotary switch (C) should be centered.
·Actuate the left and right straw walker sensors by tapping them lightly with a hard object or by dropping kernels on them. A second person is needed to observe the needle of the display. The needle must be seen to move.
II - Check cleaning shoe sensor:
·Turn potentiometer (D) clockwise as far as it will go.
·Place rotary switch (B) in the position for medium grain.
·Tumbler switch (E) should be in the middle position.
·Check cleaning shoe sensor in the same way as the straw walker sensors.
·Switch on the parking light and check whether the display light is on.
·Switch off the parking light. Disengage the threshing unit and remove the starter key.
·If a fault occurs during the check described above, have the fault rectified by your John Deere dealer.
|