Warming Up Engine
Move throttle lever back (1450/1550) until a speed of approx. 1200 rpm is achieved.
Place throttle rocker switch (CWS/WTS) in position I (1300 rpm).
Run a cold engine for approx 1-2 minutes at this speed. At ambient temperatures below freezing, extend this warming up period to 2-4 minutes.
IMPORTANT:
Never run engine without load for more than 5 minutes.
Do not increase engine speed to maximum rpm unless needle of coolant temperature gauge is in the yellow-green zone.
NOTE:
Only advance the combine when the temperature gauge registers 82 to 85°C.
|