Overthreshing

Overthreshing can be caused by excessive cylinder speed or inadequate cylinder to concave spacing.

Overthreshing can be reduced by lowering cylinder speed. As a rule, reduce the speed by only 5%. Check the result of this change before changing any other settings.

If the problem is not solved by a 10% reduction in cylinder speed, open the concave slightly. If these steps do not eliminate overthreshing, try reducing combine ground speed. A very high crop volume can cause overthreshing.

IMPORTANT: Always check results before attempting further adjustments. Never make more than a 5% adjustment at any one time.

ZCQD2080

AG,CO03622,1569 -19-17AUG99-1/1