Underthreshing

Underthreshing is the result of low cylinder speed or excessive cylinder to concave spacing.

First increase cylinder speed by 5%. If this does not solve the problem, reduce the concave to cylinder spacing slightly. Check the results after each adjustment.

In certain conditions (low level of straw in the crop) underthreshing may not be solved by these adjustments alone. If this is the case, increase the combine ground speed by selecting a faster transmission speed.

IMPORTANT: Always check results before attempting further adjustments. Never make an adjustment of more than 5% at any one time.

ZCQD2090

AG,CO03622,1570 -19-17AUG99-1/1