Replacement of Straw Chopper Knives
CAUTION:
Always jam the rotor to prevent accidents when replacing knives.
IMPORTANT:
Note the following to avoid unbalancing the straw chopper:
If excessive vibration is noted, then one of the knives has probably broken. If this is the case, immediately remove it and the knife on the opposite side, not forgetting to install new knives.
Do not sharpen the knives. Just replace them. This ensures that all knives have the same weight.
Always use 10.9 grade bolts with self-locking nuts.
Specification
|
Locking Bolt
-Torque
|
50-60 N·m (36-44 lb-ft)
|
Install the screws from left to right (facing in the direction of forward travel).
|