Changing Oil and Filter

IMPORTANT: Ensure that your hands and the engine are perfectly clean when installing replacement filter elements or changing the oil.

Run the engine for approx. 5 minutes to heat up oil.

Then shut engine off.

Bleed oil while it is still warm.

Open oil drain plug (A) or (B) and bleed off oil from crankcase.

Remove engine oil filter (see arrow).

Throw away sealing ring and clean mounting surface where sealing ring is fitted. Lubricate the new sealing ring with a thin layer of oil and install it with the new filter. As soon as the sealing ring comes into contact with the end of the filter housing tighten it by hand, applying just 1/2 to 3/4 of a turn more. DO NOT overtighten filter.

Close oil drain plug (A) or (B) again.

Fill engine with oil complying with the specified viscosity and quality. (See "Engine-Crankcase Capacity [Including Filter Change]").

NOTE: The actual capacity may vary slightly from the figure stated above. Do not overfill.

IMPORTANT: Directly after completing an oil change and/or filter change, crank the engine for 30 seconds. This ensures that all the engine components are thoroughly lubricated when the engine is started.

Start the engine and check for leaks.

Shut off engine and wait 10 minutes before checking the oil level. The oil should be between the maximum and minimum marks on the dipstick.

CQ216310
CQ190960

Filter - 6.8 L engine

CQ209010

Filter - 8.1 L engine


A-Bleeding oil - 1550
B-Bleeding oil - 1450 and CWS/WTS

AG,CO03622,2079 -19-02AUG04-1/1