Removing Combine From Storage-Engine

Check all hose clamps and coolant level.

Drain engine oil and replace with new oil if this had not already been done at the end of the harvest season. See "Fuel, Lubricants, Coolant and Capacities"section.

Check all seals.

Check battery electrolyte level (See "Battery Electrolyte Level"). Recharge battery, if necessary.

Crank engine during 5 seconds without starting. This will assure complete engine lubrication.

AG,CO03622,2175 -19-20AUG04-1/3


Procedure:

1450/1550:

This procedure is possible by disconnecting fuel supply solenoid connector (A) and cranking engine.


A-Connector

CQ213200

1550

AG,CO03622,2175 -19-20AUG04-2/3


CWS/WTS:

With combines using ECU it is necessary to disconnect connector (A) by pulling lock latch (B) from ECU (C) and cranking engine for 5 seconds.

Put the connector back in place.

Start engine and run it for approx. 5 minutes at half-rated speed.

Check all lines and seals for leaks. See your John Deere dealer, if necessary.

CQ213210

CWS/WTS


A-Connector
B-Lock latch
C-ECU

AG,CO03622,2175 -19-20AUG04-3/3