Checking Tensioner Spring Tension
A belt tension gauge will not provide an accurate measure of the belt tension when automatic spring tensioners are used. Measure tensioner spring tension using a torque wrench and following the procedure outlined below:
1. Release tension on belt using a long-bar and adequate wrench applied on cap screw (C) which has left-hand thread. Remove belt from pulleys.
2. Release tension on cap screw (C), then remove bar and wrench.
3. Put a mark (A) on swing arm of tensioner as shown.
4. Measure 20 mm (0.79 in.) from (A) and put a mark (B) on tensioner housing.
5. Rotate the swing arm using a torque wrench applied on cap screw (C) until marks (A and B) are aligned.
NOTE:
Before rotating, the torque wrench must be aligned with the tensioner fastening cap screw.
6. Record torque wrench measurement and compare with the specified values below. Replace tensioner assembly, if required.
Spring Tension Specification - 20 N·m (14.8 lb-ft)
|