Rice Concave and Cylinder - Adjustment
Adjust cylinder as close to concave to possible. Lateral clearance between cylinder teeth and concave should be at least 4 mm.
This lateral clearance of the cylinder spiked teeth should be equal to that of the first, second, third and if, equipped, the fourth row of concave teeth.
If the lateral clearance of the teeth is unequal, then different results will be produced, for example: At one extreme, ears of rice pass through the mechanism without being threshed and at the other extreme grains of rice are broken and the straw is chewed.
Adjust by positioning cylinder on separator shaft. After adjustment, lock cylinder on shaft with clamping screw (B).
NOTE:
When the machines leave the assembly line the spiked tooth cylinder has a standard teeth clearance of 4 mm. However, if during harvest season it is necessary to adjust the clearance, ask for assistance at your John Deere dealer.
|
A-Cylinder shaft
B-Clamping screw
C-Cylinder hub
X-4 mm
|