Preliminary Header AHC Calibration Procedures

IMPORTANT: Make sure that the operating position of the cutting platform and the rods is parallel to the ground before starting the calibration procedure. Header angle adjustment is dependent on tire size and is described in the "Feeder House"section.

The header height sensors are calibrated by the AHC in the header calibration procedure.

All other components of the automatic header control system are calibrated in the combine calibration procedure.

The header calibration procedure must only be performed when a header is initially installed or when header height sensors are replaced.

Header selection:

The types of headers supported are:

0 - 300 Series Flex Headers

1 - 600 Series Flex Headers

2 - Rigid Headers

3 - Corn Headers

AG,CO03622,2235 -19-11AUG04-1/2


To change the header type stored in the AHC memory, perform the following:

1. Go to address number 32 in the Infotrak. The current header type will be displayed.

2. With the starter key in position II and the road safety switch engaged, push the resume to float knob (A) on the multifunction control handle. The AHC will scroll through the available types of headers. Release the resume to float knob when the desired header type is displayed.

3. Press the fan speed key (B) on the INFOTRAK monitor to store the new header type.

NOTE: The following is a step by step procedure for header calibration, indicating operator action and system response. "r" and "l" on the display mean: "r = right" and "l = left" or "r = raise " and "l = lower".

CQ216281
CQ216580

AG,CO03622,2235 -19-11AUG04-2/2