Changing Hydraulic Oil and Filter

Changing the hydraulic oil filter:

  • According to specified time periods in the "Lubrication Chart, Periodic Service"section.
  • Whenever the hydraulic filter obstruction warning light glows on the dash.

IMPORTANT: Observe utmost cleanliness when installing filter.

Loosen and remove filter (A).

Dispose of filter properly and replace with a genuine John Deere filter.

Coat filter sealing surface with a thin layer of oil.

Tighten filter (A) by hand until sealing ring comes into contact with filter housing surface and then tighten a further 3/4 to 1-1/4 turns. Do not overtighten.

Start engine and check for leaks.

Retighten if necessary.

CQ194190

AG,CO03622,2267 -19-28MAY02-1/1