Refilling the Hydraulic System

NOTE: Only use specified oil (see "Fuel, Lubricants, Coolant and Capacities" section). Carefully clean area around filler neck before filling with fresh oil.

1. Refill with fresh hydraulic oil via the filler neck (A) until the oil reaches the center of the sight glass (B).
2. Start the combine engine and let it run for about 15 seconds. Then turn the steering wheel in both directions several times to bleed off the air still in the circuit.
3. Engage the header lift, reel lift and unloading auger drive several times in both directions, by means of their respective knobs.
4. Engage the threshing unit and the header and activate the cylinder speed control several times.
5. Inspect all lines and connections for leaks. Comply with safety recommendations.
6. With the header and reel fully lowered and the unloading auger in transport position (retracted), add oil to the reservoir until the correct level is reached.

CQ194230

AG,CO03622,2269 -19-20AUG04-1/1