|
With the reduction gear, cylinder speed can be reduced by approx. 50% (when harvesting corn).
Cylinder speeds range as follows:
Position I
- Shifter collar (A) pushed in for speeds of 380 - 1100 rpm.
Position II
- Shifter collar (A) pushed out for speeds of 150 - 420 rpm.
IMPORTANT:
Have the cylinder drive reduction gear serviced every 600 hours or every year by your John Deere dealer.
NOTE:
Cylinder drives without reduction gears must be lubricated with grease. See "Lubrication Chart, Periodic Service".
|