Replacing Cylinder Variable Drive Belt-Combines With Posi-Torq Cylinder Drive

General information

With the engine at top speed and the threshing unit engaged, use the cylinder speed control switch to fully open the beater shaft pulley (lowest cylinder speed). Disengage the threshing unit and shut down the engine.

causym CAUTION: Do not adjust belt while the engine is running.

AG,GG05155,317 -19-01SEP03-1/4


IMPORTANT: Before any disassembly, thoroughly clean the area around the connector (C) and hydraulic hose (B).

Remove hydraulic hose (B) and connector (C). Loosen and remove the clean grain elevator drive belt (D) and the separator and cleaner drive belt (E).

Remove idler pulley (A). Move the support and pin upwards and secure in this position.


A-Idler Pulley
B-Hydraulic Hose
C-Connector
D-Clean Grain Elevator Drive Belt
E-Separator and Cleaner Drive Belt

CQ179840

AG,GG05155,317 -19-01SEP03-2/4


Removing Drive Belt

On the beater's variable pulley, push the inner half pulley inward as far as possible.

There are three M12 x 150 bolts (G) with nuts and washers in the tool box. Insert these bolts in the threaded holes on the external half pulley (H) of the cylinder shaft pulley. When the bolt ends touch the inner half pulley, evenly tighten them and the two halves will begin to separate and stay in that position.

With your hand pull the belt over the outer half pulley of the beater shaft pulley (do not force).

NOTE: Before removing, check that the belt is completely seated in the bottom of the cylinder shaft pulley slot.

Pull the belt off over the cylinder shaft pulley. On the cylinder shaft pulley move the external half pulley inward approximately 50 mm loosening the three bolts (G). Remove the belt passing it through the supports (F).

IMPORTANT: After changing the belt, remove the three bolts and store them in the tool box.

To install a new belt follow this procedure in reverse order.

CQ179850
CQ179860
CQ179870
CQ179880

AG,GG05155,317 -19-01SEP03-3/4


Removing Belt on Machines with Reduction Gear

Rotate threshing cylinder through the half pulley (A) or using a wrench (See Rotating Cylinder By Hand) until the three holes (B) of reduction gear (C) are aligned with the threaded holes of outer half pulley (A).

Remove nuts (D), (E) and support (F).

There are three M12 x 150 bolts (G) with nuts and washers in the tool box. Insert these bolts fully into the threaded holes in the outer half pulley (A) of the cylinder shaft. Evenly tighten the three nuts (H) to separate the half pulleys to the maximum limit.

NOTE: Before removing, check that the belt is completely seated in the bottom of the cylinder shaft pulley slot.

With your hand pull the belt over the outer half pulley of the beater shaft pulley (do not force).

Pull the belt off over the cylinder shaft pulley.

To install a new belt follow this procedure in reverse order.

IMPORTANT: After changing the belt, remove the three bolts and store them in the tool box.

CQ209080
CQ209090
CQ179870

AG,GG05155,317 -19-01SEP03-4/4