|
A multi-viscosity diesel engine oil (SAE 15W-40) of the highest performance level, manufactured with raw materials of proven quality and containing special additives.
It is indicated for API SF/CF-4 service classification or higher.
In addition, it meets MBB228.3, MF 6610.00, VW505.00, Caterpillar TO-2, Allison C-3, Mack EO-K/2 and Cummins NTC 400 requirements. It is also approved by MWM, Perkins, Scania (complies with the Ford Tornado test) and Volvo (surpasses VDS requirements).
The following oil is also preferred:
It is possible to extend the oil change period when using John Deere PLUS-50 oil, see "Lubrication Chart, Periodic Service" section.
Other oils may be used if they meet one or more of the following requirements:
-
API CG-4 service classification
-
API CF-4 service classification
-
CCMC D5 standard
-
CCMC D4 standard
-
Mercedes Benz MB228.3
-
ACEA E3 standard
-
ACEA E2 standard
|
Multi-viscosity diesel engine oils are preferred.
If diesel fuel with sulfur content greater than 0.5% is used, reduce the service interval by 50%.
Greater service intervals may be achieved when John Deere preferred engine oils are used. Consult your John Deere dealer for more information.
ENGINE BREAK-IN OIL
New engines are filled at the factory with John Deere ENGINE BREAK-IN OIL. During the break-in period, add John Deere ENGINE BREAK-IN OIL as needed to maintain the specified oil level.
NOTE:
During the break-in period a higher-than-usual oil consumption should be considered as normal.
IMPORTANT:
During the first 100 hours, under NO circumstances must you use John Deere PLUS-50 oil or any oil that meets the following specifications: API CG-4, API CF-4, ACEA E2, ACEA E3 or CCMC D5. These oils do not satisfy the requirements for running in an engine.
Change the oil and filter after the first 100 hours of operation of a new or rebuilt engine.
|