Diesel Engine Oil-CWS/WTS

Use an oil viscosity suitable for the expected air temperature range during the period between oil changes.

The following oil is preferred:

  • John Deere PLUS-50 ®

It is possible to extend the oil change period when using John Deere PLUS-50 oil, see "Lubrication Chart, Periodic Service" section.

The following oil is also recommended:

  • John Deere TORQ-GARD SUPREME ®

Other oils may be used if they comply with one or more of the following standards:

  • API CG-4 service classification
  • API CF-4 service classification
  • ACEA E3 standard
  • ACEA E2 standard
  • CCMC D5 standard
  • CCMC D4 standard

Multi-viscosity diesel engine oils are preferred.

If diesel fuel with sulfur content greater than 0.5% is used, reduce the service interval by 50%.

Greater service intervals may be achieved when John Deere preferred engine oils are used. Consult your John Deere dealer for more information.

ENGINE BREAK-IN OIL

New engines are filled at the factory with John Deere ENGINE BREAK-IN OIL. During the break-in period, add John Deere ENGINE BREAK-IN OIL as needed to maintain the specified oil level.

TS1681

PLUS-50 is a trademark of Deere & Company.
TORQ-GARD SUPREME is a trademark of Deere & Company

CQ,ENOIL -19-20AUG04-1/2


NOTE: During the break-in period a higher-than-usual oil consumption should be considered as normal.

IMPORTANT: During the first 100 hours, under NO circumstances must you use John Deere PLUS-50 oil or any oil that meets the following specifications: API CG-4, API CF-4, ACEA E2, ACEA E3 or CCMC D5. These oils do not satisfy the requirements for running in an engine.

Change the oil and filter after the first 100 hours of operation of a new or rebuilt engine.

CQ,ENOIL -19-20AUG04-2/2