Cutting Platform Raise and Lower Speed Adjustment

Adjusting Slow Raise Speed

This adjustment is done by means of screw (A) located on the primary hydraulic valve block.

- Turn screw clockwise to decrease speed.

- Turn screw counterclockwise to increase speed.

The screw is adjusted in the assembly line with a slow raise speed considered to be average, which means it is neither fast nor too slow.

The adjustment of the slow and fast lower speed can be done in the same way through its respective valves (B) and (C).

CQ203391


A-Adjusting slow raise speed
B-Adjusting slow lower speed
C-Adjusting fast lower speed

MB03730,000001D -19-24OCT02-1/1