Area Counter-Key Functions (CWS and WTS)

Time in Hours and Minutes

When key (C) is pressed the time consumption function in hours and minutes (maximum of 99 hours and 59 minutes) will appear on the display.

The time counter can be stopped and started by repeatedly pressing the key.

Flashing colon " : " indicates that the time counter is ON.

Constant colon " : " indicates that the time counter is OFF.

The time counter can be zeroed by pressing key (G) for at least 3 seconds (only when the time counter is off)

Preparation of the time counter:

Press key (C) and the last measured time consumption will be displayed. If the colon " : " flashes (time counter on), press key (C) again and the time counter is turned off (constant colon).

Zeroing of time:

Press key (G) for at least 3 sec. and the time counter is zeroed.

Start timing:

Press key (C) and the time counter turns on (colon flashes).

Area counter now counts hours and minutes, and can be stopped and started again at any time as required.

Trip Counter

When pressing the function key (D), area in ha is displayed.

From 0 to 99.99 ha (acres) the area is displayed with 2 decimal places, and from 100 to 999.9 ha (acres) with 1 decimal place.

CQ209471


A-Digital display
B-Keyboard
C-Time consumption in hours/minutes
D-Trip Counter
E-Total Counter
F-Speed
G-Zeroing of time and area functions. This key is also used when entering the figure 0.
H-Wheel circumference
I-Encode of working width

MB03730,0000214 -19-09SEP03-1/2


Preparation of the trip counter:

Press key (D) and the last measured area is displayed.

Press key (G) for at least 3 sec. and trip counter is zeroed.

Total Counter

Press key (E) to display the total area in ha (acres) (maximum of 9999).

This function is used to check the total area worked over, for example, 1 month or 1 year.

Preparation of total counter:

Press key (E) and the last measured area is displayed.

Press key (G) for at least 3 sec. and total counter is zeroed.

The two area meters are ready for use, and even if another function is activated during work, the area meters continue counting. Usually the speed-function is activated during work, and an " r " will appear on the display whenever the area counters are off.

The area meters automatically stop/start when the implement is lifted/lowered (feeder house sensor).

NOTE: For harvesting corn it is necessary to readjust the sensor position so that the area meter is informed of its higher position in relation to ground.

The day's result can be displayed at the end of each day. At the beginning of the following day the first mentioned area meter is cleared, while the other one is automatically added to the area worked during the week.

MB03730,0000214 -19-09SEP03-2/2