Return to Cut Position for 300 and 600-CWS/WTS series Rigid Headers
IMPORTANT:
Only for rigid header without AHC rods, controlled by feeder house angle sensor.
Requirements:
·Engine running (high speed).
·Road safety switch in field position.
·Threshing and header engaged.
NOTE:
Do not adjust the header height control before the oil is heated to avoid differences in header height that may occur as the oil heats up.
To activate header automatic height control, press knob (C). The distance between platform and ground is adjusted by the potentiometer (A1).
Return To Cut Position:
Use potentiometer (A1) to adjust to desired header height.
·Turn clockwise - Increase height between header and ground.
·Turn counterclockwise - Reduce height between header and ground.
Example:
At the end of the field, raise header by actuating switch (D). After changing direction of combine travel, lower header using switch (D) or knob (C) to return to automatic header height mode.
NOTE:
The return to cut position of the header can be deactivated by pressing knob (D) or activating the header float system knob (B).
|