Header Automatic Height Control- 600-CWS/WTS Series Rigid Header

IMPORTANT: Only for rigid header with rods controlled by sensors installed on header.

Requirements:

·Engine running (high speed).

·Road safety switch in field position.

·Threshing and header engaged.

·To enable header automatic height control and tilt control move switches (E) and (F) to position (II).

NOTE: Do not adjust the header automatic height control before the oil is at working temperature, in order to avoid variations that may occur to header height as the oil heats up.

To activate header automatic height control, press knob (C).

Header automatic control knob:

See "Header AHC Calibration Procedure-Step by Step" in the "Service- Electrical System" section.

Example:

At the end of the field, raise header by actuating switch (D). After changing direction of combine travel, lower header using switch (D) or knob (C) to return to automatic header height mode.

CQ211550
CQ212540
CQ211543


C-Return to cut knob
D-Header raise/lower switch
E-Header automatic height control switch
F-Header lateral tilt enable switch

MB03730,0001BD9 -19-02AUG04-1/1