Straw Chopper Operating and Transport Position
Operating Position:
Set the straw distributor as illustrated in the "Operating position" figure and lock it in place with nuts (A and B), turning them clockwise on both sides.
Transport Position:
Loosen nuts (A or B) and raise the straw distributor until it touches combine rear as shown in the "Transport position" figure.
Lock it with latches (C or D).
NOTE:
With CWS/WTS combines, when the straw distributor is in the transport position, position the guard rail in front of baffles. See "Transport position" diagram.
A-1450/1550 Straw distributor nut
B-CWS/WTS Straw distributor nut
C-1450/1550 Straw distributor locking latch
D-CWS/WTS Straw distributor locking latch
|