Engaging Straw Chopper

causym CAUTION: Before engaging the straw chopper, always switch off all drives (separator, unloading auger and header), shut off the engine and wait until all moving parts have come to a stop.

The deflector sheet (A) can be assembled in two positions, depending on the crop.

With deflector sheet (A) in position I, the straw falls on the ground and is not chopped.

With deflector sheet (A) in position II, the straw from the straw walkers passes into the straw chopper and is chopped.

IMPORTANT: With deflector sheet (A) in position I, the straw chopper must be disengaged (remove belt) to avoid damage to the sheet by straw chopper knives.

With deflector sheet (A) in position II, the straw chopper must be engaged.

1450/1550 Combines:

1. Remove three bolts (B) on both sides of the machine.
2. Move the deflector sheet forward (position II) or backwards (position I).
3. Retighten bolts.

CWS/WTS Combines:

Swinging the deflector sheet from one position to the other is done by means of the lever shown in the figure.

Move the lever forward (position II) or backwards (position I).

CQ209190

Deflector sheet in position I

ZX012167

Deflector sheet in position II

CQ209281

Deflector sheet lever (CWS/WTS)

ML70882,00003F7 -19-14NOV03-1/1