Reducing Straw Chopper Rotational Speed

The adjacent figures illustrate installation of the belt for the majority of crops.

When harvesting corn or sunflowers, rotor speed should be reduced.

1. Open shields (A) and (B). More details in the "Service-Drives and Shields" section.

2. Loosen and remove the belt from pulleys (C) by means of lever (D). Turn pulleys (C) so that the part that was on the outer side is now on the inner side. This permits the correct alignment of the idler pulleys with the intermediate pulleys of the rotor.

3. Install the belt on the intermediate pulley (F). The smaller diameter of drive pulley (F) is recommended for corn and sunflowers, while the bigger diameter of drive pulley (E) is recommended for most other crops

4. Install the belt on pulley (H). The larger diameter of pulley (H) is recommended for corn, while the smaller diameter of pulley (G) is recommended for most other crops.


A-Shield
B-Shield
C-Idler pulleys
D-Lever
E-Bigger intermediate pulley
F-Smaller intermediate pulley
G-Smaller rotor pulley
H-Bigger rotor pulley

CQ209040
CQ203861
CQ203871
CQ192211

ML70882,00003F8 -19-14NOV03-1/1